Hello
Does anyone know if SiS 900 ethernet is supported in the latest version? The Wiki lists this card as supported but it is not mentioned in the bundled documentation. I have tried to configure ethernet with no success. Any advice would be welcome.
Thanks
SiS 900 ethernet card
The driver is present, but I dont know if it's working in the latest kernels, as I do not own one of these cards personally.
Try to run AUTODHCP and look in the debug board, user tab, what it has to say.
Good luck,
and welcome to the forums
Try to run AUTODHCP and look in the debug board, user tab, what it has to say.
Good luck,
and welcome to the forums
"Any intelligent fool can make things bigger, more complex, and more violent. It takes a touch of genius -- and a lot of courage -- to move in the opposite direction." Albert Einstein
Thanks hidnplayr
I did as you suggest with the following output from the debug board:
K = New Process - done
K = Kernel error
K = Process - forced terminate INT:0000000E
K = Process - forced terminate PID:00000033
K = Process - forced terminate EIP:80023506
K = Process - terminating
K = Process - done
K = Process - terminating
K = Process - done
K = Process - terminating
K = Process - done
I guess this means the driver is broken at present. I will try my serial modem.
Many Thanks
I did as you suggest with the following output from the debug board:
K = New Process - done
K = Kernel error
K = Process - forced terminate INT:0000000E
K = Process - forced terminate PID:00000033
K = Process - forced terminate EIP:80023506
K = Process - terminating
K = Process - done
K = Process - terminating
K = Process - done
K = Process - terminating
K = Process - done
I guess this means the driver is broken at present. I will try my serial modem.
Many Thanks
solo
Which version are you using? Judging from the message - old. Use the last.
Which version are you using? Judging from the message - old. Use the last.
Hi Ghost
Yes, that is the answer, I can connect now.
Many Thanks.
Yes, that is the answer, I can connect now.
Many Thanks.
Happy to help. Good luck!
Who is online
Users browsing this forum: No registered users and 5 guests