K : HPET caps 8086A201 K : using mwait for idle loop K : kernel SVN r6297 K : 2 CPU detected K : Attach Interrupt 6 Handler 80038609 K : Set IDE IRQ6 return code 80062F80 K : IDE controller programming interface 0001018A K : BAR0 IDE base addr 01F0 K : BAR1 IDE base addr 03F4 K : BAR2 IDE base addr 0170 K : BAR3 IDE base addr 0374 K : BAR4 IDE controller register base addr FFA0 K : IDE Interrupt 00 K : IDE controller programming interface 0001018F K : BAR0 IDE base addr E080 K : BAR1 IDE base addr E000 K : BAR2 IDE base addr DC00 K : BAR3 IDE base addr D880 K : BAR4 IDE controller register base addr D800 K : IDE Interrupt 0B K : Channel 1 Disk 0 K : Device not found K : Channel 1 Disk 1 K : Device not found K : Channel 2 Disk 0 K : Device not found K : Channel 2 Disk 1 K : Device not found K : Channel 1 Disk 0 K : Dev: ST380815AS K : PIO possible modes 03 K : PIO set mode 01 K : Multiword DMA possible modes 07 K : Multiword DMA set mode 00 K : Ultra DMA possible modes 7F K : Ultra DMA set mode 05 K : Channel 1 Disk 1 K : Device not found K : Channel 2 Disk 0 K : Device not found K : Channel 2 Disk 1 K : Device not found K : IDE CH1 PIO because no devices K : IDE CH2 PIO because no devices K : Attach Interrupt 14 Handler 80039238 K : Set IDE IRQ14 return code 80062F94 K : Attach Interrupt 15 Handler 80039238 K : Set IDE IRQ15 return code 80062FA8 K : IDE CH1 DMA enabled K : IDE CH2 PIO because no devices K : Attach Interrupt 11 Handler 80039238 K : Set IDE IRQ11 return code 80062FBC K : driver /rd/1/drivers/vidintel.sys mapped to 80D72000 Intel videocard detected, PciId=8086:29C2, which is known EDID successfully read: 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 02 00 00 00 K : driver /sys/drivers/UHCI.sys mapped to 80D76000 K : driver /sys/drivers/EHCI.sys mapped to 80D73000 K : has_ownership K : HCSPARAMS=00104208, HCCPARAMS=00006871 K : Attach Interrupt 5 Handler 80D738E6 K : EHCI controller at 00:EF with 8 ports initialized K : UHCI controller at 00:E8 with 2 ports initialized K : Attach Interrupt 5 Handler 80D766C1 K : UHCI controller at 00:E9 with 2 ports initialized K : Attach Interrupt 11 Handler 80D766C1 K : UHCI controller at 00:EA with 2 ports initialized K : Attach Interrupt 3 Handler 80D766C1 K : UHCI 80D85830 connect status changed, 0082/0080 K : UHCI controller at 00:EB with 2 ports initialized K : Attach Interrupt 10 Handler 80D766C1 K : cpu frequency 2000020000 Hz K : Attach Interrupt 1 Handler 8003A1C0 K : IRQ1 return code 80063034 K : driver /rd/1/drivers/PS2MOUSE.SYS mapped to 80E93000 K : Attach Interrupt 12 Handler 80E93567 K : EHCI 80D7E0A4: status of port 4 changed to 00001803 L: /SYS/SETUP Param: BOOT L: /SYS/LOADDRV Param: RDC K : driver /sys/drivers/RDC.sys mapped to 80EA1000 L: /SYS/@TASKBAR Param: L: /SYS/@ICON Param: L: /SYS/ESKIN Param: K : EHCI 80D7E0A4 port 4 state is 00001801 K : EHCI 80D7E0A4: port 4 has HS or FS device, resetting L: /SYS/@DOCKY Param: L: /SYS/NETWORK/NETCFG Param: A L: /SYS/NETWORK/@ZEROCONF Param: Zero-config service loaded K : EHCI 80D7E0A4 status of port 4 is 00001005 L: /SYS/@VOLUME Param: K : driver /sys/drivers/SOUND.sys mapped to 80EE0000 Detecting hardware... Loading INTEL_HDA K : driver /sys/drivers/INTEL_HDA.sys mapped to 80EF3000 HDA test version 019 detect hardware... Intel ICH7 PCI command 00000006 PCI status 00000010 lower mmio base FE8F8004 upper mmio base 00000000 GCAP = 00004401 codec_mask = 00000001 create primary buffer ...done K : Attach Interrupt 10 Handler 80EF3A4C K : device descriptor: 12 01 10 02 00 00 00 40 51 09 66 16 01 00 01 02 03 01 K : found USB device with ID 0951:1666, 1 configuration(s) codec probed OK CAd = 0 K : config descriptor: 09 02 20 00 01 01 00 80 FA 09 04 00 00 02 08 06 50 00 07 05 81 02 00 02 FF 07 05 02 02 00 02 FF K : USB interface class/subclass/protocol = 08/06/50 K : driver /sys/drivers/usbstor.sys mapped to 80F08000 K : USB mass storage device detected L: /SYS/@SS Param: ASSM K : 1 logical unit(s) K : media is ready K : 0 attempts, 0 ticks K : peripheral device type is 00 K : direct-access mass storage device detected K : sector size is 512, last sector is 60437491 Setup FG nodes = start_nid:total_nodes = 1:1 L: /SYS/TMPDISK Param: A0 FG type = 1 Setup FG nodes = start_nid:total_nodes = 2:25 K : driver /sys/drivers/tmpdisk.sys mapped to 81011000 пробую добавить виртуальный диск его размер не указан, 20% свободной ОЗУ будет использовано размер диска будет: 200 MB операция успешно завершена L: /SYS/SEARCHAP Param: Realtek ALC662 Pin Nid = 14 Pin Control = 00000020 Pin Capabilities = 0001003C Pin def_cfg = 01014010 Pin Amp Out caps = 80000000 AUD_OUT found 2 UNMUTE OUT: NID=2 Amp val = 40:3 CONNECT: NID=C IDX=0 UNMUTE OUT: NID=14 Enable EAPD: NID=14 UNMUTE OUT: NID=14 Enable EAPD: NID=14 Pin Nid = 1B Pin Control = 00000020 Pin Capabilities = 0000173C Pin def_cfg = 02214020 Pin Amp Out caps = 80000000 AUD_OUT found 2 UNMUTE OUT: NID=2 Amp val = 40:3 CONNECT: NID=C IDX=0 CONNECT: NID=1B IDX=0 UNMUTE OUT: NID=1B UNMUTE OUT: NID=1B val=2 val=2 hda_codec_setup_stream: NID=2 stream=1 channel=0 format=11 Normal mode ! NewVolume: 0000095B MinVolume: 000012C0 Searchap: compare files - success! Searchap: mount directory: /usbhd0/1 L: AUTORUN.DAT processed K : driver /tmp0/1/i915.dll mapped to 8DA15000 i915 v4.4.3 build Feb 29 2016 23:21:27 usage: i915 [options] --rc6 <-1,0-7> Enable power-saving render C-state 6. Different stages can be selected via bitmask values (0 = disable; 1 = enable rc6; 2 = enable deep rc6; 4 = enable deepest rc6). For example, 3 would enable rc6 and deep rc6, and 7 would enable everything. default: -1 (use per-chip default) --fbc <-1,0,1> Enable frame buffer compression for power savings (default: -1 (use per-chip default)) -l --log path to log file -m --mode set videomode -v --video :x[M][R][-][@][i][m][eDd] set videomode for CONNECTOR LOG: i915 v4.4.3 build Feb 29 2016 23:21:27 sys_alloc 592 bytes os_mmap 8d8cb000 131072 bytes PCI device 8086:27b8 bus:0 devfn:f8 PCI device 8086:29c2 bus:0 devfn:10 PCI device 8086:29c0 bus:0 devfn:0 <6>SMBIOS 2.4 present. <7>DMI: System manufacturer System Product Name/P5KPL-VM, BIOS 0802 03/26/2008 <6>[drm] device 8086:29c2 Info intel_gmch_probe Intel G33 Chipset Error intel_i9xx_setup_flush can't ioremap flush page - no chipset flushing Info intel_gtt_init detected gtt size: 524288K total, 262144K mappable Info intel_gtt_stolen_size detected 8192K stolen memory <6>[drm] Memory usable by graphics device = 512M <6>[drm] enable MCHBAR <6>[drm] Supports vblank timestamp caching Rev 2 (21.10.2013). <6>[drm] Driver supports precise vblank timestamp query. K : Attach Interrupt 10 Handler 8DA42270 i915_driver_thread enter intel_hpd_irq_handler leave intel_hpd_irq_handler Info drm_fb_helper_single_fb_probe fb0: inteldrmfb frame buffer device enter init_display_kms object 0x00564000 [fenceable? 1] not 1M or pot-size (0x00800000) aligned WARNING: at i915_gem_fence.c:132 enter i915_hotplug_work_func cursor on pipe A assertion failure (expected off, current on) WARNING: at intel_display.c:1340 cursor on pipe A assertion failure (expected off, current on) WARNING: at intel_display.c:1340 leave init_display_kms Set DISPLAY handler leave i915_hotplug_work_func pci id for -2138917632: 8086:29c2, driver i915 mesa-9.2.5-i915_dri build Feb 6 2016 00:16:26 EGL_VERSION = 1.4 (DRI2) px_create_image w:1280 :1024 pitch:8192 handle 1 create mask bo handle 7 name 3 create mask image 0x2afca48 Render: i915_dri.drv 2765 frames in 5.0 seconds = 553.000 FPS 3434 frames in 5.0 seconds = 686.800 FPS 3429 frames in 5.0 seconds = 685.800 FPS 3424 frames in 5.0 seconds = 684.800 FPS 3409 frames in 5.0 seconds = 681.800 FPS 3351 frames in 5.0 seconds = 670.200 FPS 3381 frames in 5.0 seconds = 676.200 FPS 3421 frames in 5.0 seconds = 684.200 FPS K : destroy app object 3399 frames in 5.0 seconds = 679.800 FPS 3434 frames in 5.0 seconds = 686.800 FPS